SURFACE TENSION ANALYZER

Articles

• GLASS FAILURE ANALYSIS
  19 July 2018, by Thomas Lietart

  GLASS FAILURE ANALYSIS : Investigation, Analysis and Failure Analysis
  Glass is a material apart, discovered thousands of years ago. Our knowledge about it, as well as the capacity to analyze it and carry out a failure analysis are more recent. Like every material, it is important to know the characteristics of glass materials and enamels as part of assembly control, of both the container and content as well as in cases of defects or failures.
  The Analyses & Surface laboratory (...)

• Characterization of coating strength
  17 June 2015, by Administrateur

  CHARACTERIZATION OF COATING STRENGTH: The characterization of surface coatings
  The Analyses & Surface CRT is equipped with standardized hardware and has developed the skills to meet the increasingly stringent technical and regulatory requirements (higher temperatures, more aggressive environments, vibration, high stress, high pressures, REACH recommendations or standards, etc.). These parameters require evaluation and the qualification of coatings and their refractory life according to (...)

• SURFACE TENSION ANALYZER
  24 July 2018, by Thomas Lietart

  To complete our installed base of equipment in terms of surface characterization, the laboratory has been equipped with a DSA30 Drop Shape Analyzer.
  The equipment is a characterization tool for materials and surfaces that can be used flexibly for the precise measurement of contact angles and surface energy. The equipment enables the analysis of wettability and adhesion on solid surfaces.
  Analysis of solids and liquids In addition to measuring the contact angle, our equipment can also (...)

• Reliability of electronic components
  17 June 2015, by Administrateur

  THE RELIABILITY OF ELECTRONIC COMPONENTS: Determining the cause of a failure in an electronic component
  Finding a defect on a chip card and its components can be very long and difficult due to the size of the various existing electronic components. The occurrence of a fault even within a component can make its characterization difficult because of its size and the ability to disassemble it. Industrialists must be able to carry out the investigations required to solve the problem in order (...)